IC Realtime Specialty: 4-CH Mobile DVR - Manual (Page 110)

110
Parameter Function
Save You can click save button after you complete setup for one channel,
or you can complete the whole setups and then click save button.
Refresh Click this button to get device latest configuration information.
7.3.2.8 PTZ
PTZ interface is shown as in
X470H470H470H440H440H440H447H410H
Figure 7-42
X
Please note, before operation please make sure you have set speed dome address. And DVR
and speed dome connection is OK.
Figure 7-42
Please refer to the following sheet for detailed information.
Parameter Function
Channel
You can select monitor channel from the dropdown list. .
Protocol
Select the corresponding dome protocol.(such as PELCOD)
Address
Set corresponding dome address. Default value is 1. Please note your
setup here shall comply with your dome address; otherwise you can
not control the speed dome.
Baud
Rate
Select the dome baud rate. Default setup is 9600.
Data Bit Default setup is 8. Please set according to the speed dome dial switch
setup.
Stop bit
Default setup is 1. Please set according to the speed dome dial switch
setup.
Parity Default setup is none. Please set according to the speed dome dial
switch setup.