Heli-Max HMXE0821 - Manual (Page 10)

10
INSTALL THE FLIGHT BATTERY
Slide the battery into the helicopter.
Make sure the battery is slid all the
way to the front of the battery tray. Take
extra care in making sure the wires
don’t come in contact with any of the
moving parts.
Warning! Once the flight battery has
been connected, the helicopter will
have full power available. Now is a good
time to turn on the HOLD/FLAP switch.
With the helicopter sitting still on a flat
surface, connect the flight battery to the
ESC. The helicopter must remain still
for the gyro to initialize properly. This
process takes approximately 5 seconds
or so. Turn off the HOLD/FLAP switch.
The helicopter is ready to go.
®
FLYING YOUR AXE100 CP FLYING YOUR AXE100 CP
Takeoff: During your first flights it is important to have light winds. Also, if you
are flying from grass, place a rubber mat or pad down on the grass so the small
rotating parts don’t get hung up on the grass.
Slowly add power and observe the model. The AXE100 CP has the incredible
Heli-Max TAGS system. The TAGS system takes care of all the center trim function
the transmitter might have. Having said this, you do not need or want to move
the trim buttons during flight.