Heli-Max HMXE0839 - Manual (Page 14)

14
™
Your BLACK HAWK uses the Tactic SLT protocol. This means, with the simple
addition of the Tactic Anylink to your favorite transmitter, you can enjoy your
Heli-Max BLACK HAWK with a familiar transmitter. After the purchase of your
Anylink, make sure to fully read the instructions so you understand how to
properly and safely use the Anylink system.
When using the Anylink you must make sure to follow the proper
mapping procedure for your radio brand. Failing to do so could cause
an unsafe condition. How to map your transmitter, as well as a list of
compatible transmitters, is included with your Anylink. You can fi nd
this and more information on the Tactic website, www.tacticrc.com.
linking
The Tx-R version of the BLACK HAWK requires you to link your transmitter to
the helicopter. When using a Tactic SLT transmitter or Anylink one must follow
the procedure below to complete the task. If you need to link or re-link for any
reason, here is the proper procedure to do so.
1. Turn on the transmitter, making sure all the switches are in the back
position and the throttle is down.
2. Remove the canopy from
the helicopter and locate
the small black button near
the front of the PC board.
3. Place the transmitter in close proximity to the helicopter (1 to 2 feet away).
4. Plug a fully charged the battery into the helicopter.
5. Press and hold the Link button for 3 seconds or until the LED remains on.
6. Monitor the fl ashing LED. When it stays on without fl ashing your
transmitter is now linked to the helicopter. Note: there is a second LED in