Heli-Max HMXE0839 - Manual (Page 11)

11
getting the model ready to fly
Install Batteries In The Transmitter
Remove the battery cover
from the back of the transmitter
and install eight “AA” batteries
into the transmitter. Double-
check the polarity of each
battery before replacing the
battery cover.
Charge the Flight Battery
Plug the wall power supply into
any 110V standard outlet. Plug
the remaining 4mm plug into the
side of the charger box.
The Red LED will light and
the charger will sound a beep
letting you know your charger is
receiving power.
Plug the battery’s balance lead
(the white connector) into the side
of the charger. The charger will
again beep and the green LED
will start to fl ash. Charging is
complete when the charger beeps and the red and green light remain on.
WARNING: NEVER leave your charger unattended when charging and never
leave the battery pack plugged into the charger after completion.