GTCO Surface-Lit AccuTab - Users Guide - Manual (Page 4)

Surface-Lit AccuTab 4
Parts Checklist
 AccuTab Series or Surface-Lit AccuTab Series digitizing tablet
 AccuTab controller
 Power supply
 Transducer (cursor)
 Computer interface cable with 9-pin connector
 9- to 25-pin adapter
 TabletWorks CD
NOTE: AccuTab controller is the small enclosure attached to the back of the tablet that
contains the electronics that drive the digitizer.
What You Will Need to Use AccuTab
 Computer with an RS-232C communication port
 Graphic application software that accepts digitizer input
Care and Handling
 To clean the tablet, GTCO CalComp by Turning Technologies recommends using any
non-abrasive cleaner that is appropriate for cleaning kitchen counter tops.
 To clean the cursor body, use a mild cleanser. Do not spray the cleanser directly on
the cursor, instead dampen a soft cloth with a mixture of water and the cleanser.
 Clean cursor reticles with alcohol.
NOTE: Excessive cleaning can dissolve the filled black cross hair on a reticle.
Installing AccuTab
The following instructions provide information on how to put the AccuTab system together
and attaching it to the computer.
Mounting a Large AccuTab Tablet
The AccuTab can be placed on a table, desk or drafting table. Alternatively, you can mount
a tablet on a workstation stand available from a variety of manufacturers. Instructions will
be packed with the stand. GTCO CalComp by Turning Technologies also provides Universal
Mounting Brackets, as an option, that allow the digitizer to be mounted to virtually any