GTCO Surface-Lit AccuTab - Users Guide - Manual (Page 11)

Surface-Lit AccuTab 11
Using the AccuSet Menu
Use the AccuSet Menu to:
 Configure AccuTab for specific application programs
 Use the Custom Configuration Menu
 Control the alarm
 Reset the AccuTab
 Control the Illuminated Cursor lamps
Configuring for Specific Application Programs
You can use the AccuSet Menu to quickly change the AccuTab’s operating characteristics to
match those required by different application programs running on the computer.
To configure AccuTab for use with specific application programs:
1. In Table 1, find the application program you’ll be using with AccuTab. Please note
the corresponding AccuSet Code.
 If your application program is not listed in Table 1, find the configuration
settings that apply to your application program in Table 2 and use that
AccuSet Code.
 If an appropriate AccuSet Code is not listed in Table 2, then use the Custom
Configuration Menu to set up the AccuTab.
2. Select the block on the AccuSet Menu. This lets the AccuTab know you are
about to set a new configuration. You will hear one short beep.
NOTE: The proximity light will turn on only when the transducer is over a AccuSet
Menu block that is a valid selection (for example, the proximity light will not turn on
over a digital block until the block has been selected).