GTCO Roll-Up II - Users Guide - Manual (Page 42)

Roll-Up II 42
CalComp Emulation Commands
Roll-Up II recognizes a subset of the CalComp 9500 command set. Space does not permit a
detailed description of CalComp commands. However, most of the commands in this
subset have equivalent Roll-Up II commands. For further information about the operation
of those commands, please refer to the Roll-Up II command or function description in the
GTCO CalComp by Turning Technologies Roll-Up II Command Summary.
NOTE: CalComp commands must be terminated with a , which is not shown in the
codes listed here. Commands can be strung together by substituting an @ character for
the % sequence after the first command and postponing the until the end of
the multiple command string.