GTCO Roll-Up II - Users Guide - Manual (Page 20)

Roll-Up II 20
Example: Configuring for Specific Application Programs
To configure Roll-Up II to operate with Autodesk’s AutoCAD application program:
1. Find the entry for AutoCAD in Table 1. The SuperSet code is 01.
2. Select on the SuperSet Menu. This places the digitizer in Select Mode.
3. Choose on the SuperSet Menu. This enters the first digit of the SuperSet code
for AutoCAD.
4. Select on the SuperSet Menu. This enters the second digit of the SuperSet
code for AutoCAD.
5. You will hear four short tones, indicating that the configuration is complete. The
Roll-Up II is now configured to operate with AutoCAD. Select Mode is no longer
active.
NOTE: After beginning Select Mode, you must digitize only in the number blocks to
properly enter a SuperSet code. If you digitize in the tablet’s active area during Select
Mode, the sequence will be terminated and the previous configuration will be retained (you
will hear three medium-length tones after an aborted sequence). To cancel a sequence if
the first digit is entered incorrectly, digitize in the tablet’s active area.
Introduction to the Custom Configuration Menu
Roll-Up II uses the Custom Configuration Menu to control baud rate, data format and other
operating characteristics. The Custom Configuration Menu card is stored in one end of the
digitizer’s housing.
Configuration parameters for Roll-Up II are divided into three categories:
 Communication Options
 Output Format Options
 Mode Options