Great Planes Seawind .60-.91 ARF - GPMA1360 - Manual (Page 19)

❏
2. Insert and glue the wing tip support in the tip rib of the
left wing.
❏
3. Test fit the left fiberglass wing tip on the left wing panel.
The wing tip curves downward. Use a felt-tip pen to mark the
outline of the wing tip on the wing.
❏
4. Remove the wing tip and use a sharp hobby knife to trim
the covering from inside the wing tip outline.
❏
5. Use epoxy to glue the wing tip to the wing. Make sure
that the tips are well sealed to the wing to prevent any water
from getting in. You may want to apply clear tape or silicone
sealant around the edges of the wing tips to seal them.
❏
1. Insert the aluminum wing joiner in the fuselage. Space it
evenly on both sides of the fuselage.
❏
2. Route the servo wires and air line tubing, if retracts are
installed, through the holes in the fuselage.
❏
3. Secure the wing panels to the fuselage with two black
finger bolts. If you will be flying off of water, we recommend
that clear tape be used to seal the joint between the wing
panels and fuselage.
FINISH THE RADIO INSTALLATION
19