Great Planes PT-E Trainer Electric Kit - GPMA0110 User Manual

Page 6

GET READY TO BUILD

D 1. Unroll the plan sheet. Re-roll it inside out to make

it lie flat. Note: The fuselage plan is printed on Side

1 and the wing plan is printed on Side 2.

D 2. Remove all parts from the box. As you do, figure

out the name of each part by comparing it with the
plans and the parts list. Using a felt tip pen, write
the part name or size on each piece to avoid confu-
sion later. Be especially careful to identify the sticks
correctly, as there are several sticks having the same
width but differing thicknesses. Use the die cut pat-

terns shown below to identify the die cut parts and
mark them before punching out. Save all scraps. If
any of the die-cut parts are difficult to punch out, do
not force them! Instead, first cut around the parts
with an Xacto knife.

NOTE: After punching out the die cut parts, use your

T-Bar or sanding block to lightly sand the edges to remove

any die-cutting irregularities.

D 3. As you identify and mark the parts, separate them

into groups, such as fuse (fuselage), wing, fin &
stab (stabilizer), and hardware.