Great Planes Giant Citabria 30cc/EP ARF - GPMA1435 - Manual (Page 32)

32
❏
2. Install your receiver battery of choice to either side of the
fuselage. Place a piece of R/C foam rubber under the battery
and secure the battery with Velcro
® . Plug your servos into
the receiver, place R/C foam under the receiver and secure
it with Velcro
® .
❏
3. Install a 20" [500mm] servo lead into the aileron and the
flap port of your receiver.
❏
4. Install a dual servo lead or “Y” harness on the flap leads
and the aileron leads in your wing.
INSTALL THE COCKPIT,
PILOT AND SPINNER
❏
1. Locate the cockpit floor and the seat backs. Glue the
seat backs to the cockpit floor.
❏
2. Remove the windshield and un-do the Velcro® holding
the fuel tank in place. Test fit the cockpit floor inside the
fuselage. The cockpit floor is pre-cut and should fit without any
modifications. The easiest way to install the floor is through
the front of the cockpit. When it is properly positioned on the
frame the fuel tank will overhang slightly on the floor.