Great Planes Cirrus SR22 .46-55 ARF - GPMA1363 - Manual (Page 20)

20
❏
4. Place the plywood fuel tank spacer over the neck of
the fuel tank.
❏
5. Install three pieces of fuel tubing (not included) on the
aluminum tubes exiting the fuel tank. Mark the pressure
tubing. Glue a piece of RC foam to the fuel tank tray. This will
keep the fuel tank from sliding around. Route the fuel tubing
and the neck of the fuel tank through the hole in the fi rewall.
❏
6. Make a hook and loop strap (as you did for the receiver)
and secure the fuel tank to the fuel tank tray. Connect one
of the fuel lines from the clunk to the carburetor. The second
line from the clunk will be routed out the bottom of the cowl
and used to fi ll and drain the fuel tank.
❏
7. Install the muffl er and connect the fuel line from the
pressure tube to the muffl er. The end of the muffl er screw
may need to be fi led down if the screw is hitting the fuselage.
Install the Cowl
❏
1. Tape a piece of card stock to the bottom of the fuselage.
Trim the card stock around the muffl er.