Great Planes Cirrus SR22 .46-55 ARF - GPMA1363 - Manual (Page 13)

13
❏
3. Use sandpaper to roughen the nose gear wire (where
shown) and the slot in the wheel pant. Then clean both
areas with a paper towel dampened with denatured alcohol.
❏
4. Insert the nose gear wire in the wheel pant. Apply a
drop of thread locker to a 6-32 x 1/4" [6mm] socket head cap
screw. Thread the cap screw into a 4mm wheel collar. Slide
the wheel collar on the nose gear wire and tighten the cap
screw on the lower fl at spot.
❏
5. Apply a drop of thread locker to a 3x4mm set screw.
Install the set screw in the nose gear axle, opposite the cap
screw in the wheel collar.
❏
6. Install the nose gear axle assembly on the nose gear
wire. Tighten the set screw on the fl at spot at the end of the
nose gear wire.
❏
7. Use epoxy or RTV Silicone glue to glue the nose gear
wire in the slot of the wheel pant. Make sure the foam wheel
is aligned in the wheel pant and the wheel collar is next to
the top of the wheel pant.
❏
8. Center the nosegear decal on the front of the nosegear
and wrap around the sides.