Great Planes Cirrus SR22 .46-55 ARF - GPMA1363 - Manual (Page 19)

19
connector with a nylon retainer. Switch on the radio system.
Center the throttle stick on the transmitter and install a servo
arm on the throttle servo perpendicular to the centerline of
the servo.
❏
11. Make the bends necessary to align the pushrod with
the pushrod connector. Insert the pushrod in the connector.
Apply a drop of thread locker to the threads of a 4-40 x 1/4"
[6mm] socket head cap screw. Install the cap screw in the
pushrod connector. With the radio system switch on and the
throttle stick centered, center the barrel of the carb, then
tighten the cap screw in the pushrod connector.
Setting the throttle up this way will only require a small
amount of end point adjustment, if any. We also recommend
that a throttle-cut be set up on a switch on your transmitter.
Install the Fuel Tank
❏
1. Insert the one long and two short aluminum tubes
through the large fuel tank stopper plate, rubber fuel tank
stopper and the small fuel tank stopper plate. Thread the
fuel tank stopper screw into the small fuel stopper plate.
Do not tighten the screw.
❏
2. Make a 90° bend in the long aluminum tube (pressure
tube). Do not kink the tube. Install the two silicone fuel tubes
on the short aluminum tubes. Trim the fuel tubing so that
the metal clunks are able to move in the fuel tank. Install the
metal clunks on the fuel tubing.
❏
3. Insert the fuel tank stopper in the fuel tank. Make sure
that the pressure tube is toward the top of the fuel tank.
Tighten the fuel tank stopper screw.