Golden Lighting 8118-SF PW - Manual (Page 4)

INSTALLATION INSTRUCTIONS
Fixture Name: Alston Place 8118-SF BUS
For Semi Flush / Convertible Light Fixture
WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.
HANGING THE FIXTURE as Chain Hung (Fig. 1)
1. Carefully remove the new fixture from the carton and the yellow
bag that holds all parts. Check that all parts are included as shown in
the illustration and parts list.
2. Shut off the power at the circuit breaker and remove old fixture
from ceiling, including the old mounting strap.
3. Thread Nipple (C) into Canopy Loop (F) until snug.
4. Thread other end of the Nipple (C) with Canopy Loop attached
into Mounting Strap (D).
5. Place Lock Washer (B) over end of Nipple (C) protruding through
Mounting Strap (D). Thread Hex Nuts (A) onto Nipple (C) until tight.
6. Take this mounting strap assembly and mount to ceiling junction
box with junction box Screws (E). Tighten screws securely with
screwdriver.
7. Unscrew the Canopy Loop Collar (H) from the Canopy Loop (F).
Take the canopy and pass over the canopy loop. Approximatly half
of the canopy loop exterior threads should be exposed. Adjust until
desired height is reached. *The Canopy loop collar should fit snugly
on the Canopy loop after the canopy is installed. Remove Canopy
and Canopy lock collar.
8. Assemble the fixture and have an assistant support the weight of
the fixture while you complete the wiring connections.
9. Thread the fixture wires and ground wire of the assembled fixture
through the canopy loop and nipple, and into the outlet box.
Fig. 1
CONNECTING THE WIRES (Fig. 2)
10. Attach the power supply wires to the fixture lead wires by
connecting BLACK to BLACK (or SMOOTH) and WHITE to WHITE
(or RIBBED).
NOTE: Twist the wires together in the same direction you twist the
wire connector onto the wires.
11. Attach the GROUND wire (GREEN or COPPER) from the
junction box and the fixture ground wire to the green ground screw on
the Mounting Bracket (D). Or, connect both wires together using a
wire connector.
12. Tuck these wire connections neatly into the junction box.
Fig. 2
FINISHING THE INSTALLATION
13. Raise the Canopy (G) to the ceiling. Secure in place by
tightening the Canopy Loop Collar (H) onto the Canopy Loop (F).
14. Install the light bulbs and glass shade according to the fixture
assembly sheet.
YOUR INSTALLATION IS NOW COMPLETE.
RETURN POWER TO THE JUNCTION BOX AND
TEST THE FIXTURE.
For Customer Service, contact the place of purchase to arrange for replacement parts.