Golden Lighting 8118-SF PW - Manual (Page 3)

INSTALLATION INSTRUCTIONS
Fixture Name: Alston Place 8118-SF BUS
For Semi Flush / Convertible Light Fixture
WARNING ! SHUT OFF POWER AT FUSE OR CIRCUIT BREAKER.
HANGING THE FIXTURE as Semi flush (Fig. 1)
1. Carefully remove the new fixture from the carton and the
yellow bag that holds all your parts. Check that all parts are
included as shown in the illustration and parts list.
2. Shut off power at the circuit breaker and remove the old
fixture from ceiling, including the old mounting strap.
3. The Circular Strap (A) contains several pairs of threaded
holes, find the pair of holes that match the hole spacing in your
fixture Back Plate (D) and thread the two Mounting Screws (C)
halfway into the Mounting Strap. Secure in place with hex nuts.
The screws will have their threaded ends protrude through the
two holes in the fixture canopy (D).
4. Place the Mounting Strap (A) over the junction box.
5. Attach the Mounting Strap (A) to the junction box using the
two Mounting Screws (B). Tighten the screws (B) securely with
a screwdriver.
Fig. 1
CONNECTING THE WIRES (Fig. 2)
6. Attach the power supply wires to the fixture lead wires by
connecting BLACK to BLACK (or SMOOTH) and WHITE to
WHITE (or RIBBED).
NOTE: Twist the wires together in the same direction you twist
the wire connector onto the wires.
7. Attach the GROUND wire (GREEN or COPPER) from the
junction box and the fixture ground wire to the green ground
screw on the Mounting Bracket (B) or connect both wires
together using a wire connector.
8. Tuck these wire connections neatly into the junction box.
Fig. 2
FINISHING THE INSALLATION (Fig. 3)
9. Place the fixture’s canopy over the Mounting Strap (A) and
over the Mounting Screws (C). Adjust the fixture Canopy (D)
until the Mounting Screws (C) protrude out from the canopy
(D). Secure the fixture against the ceiling by threading the
decorative nuts (E) until tight.
10. Install the light bulbs and glass shade as per the fixture
assembly sheet.
YOUR INSTALLATION IS NOW COMPLETE. RETURN
POWER TO THE JUNCTION BOX AND TEST THE FIXTURE.
Fig. 3
For Customer Service, contact the place of purchase to arrange for replacement parts.