Golden Lighting 3500-SF AB - Manual (Page 2)

For Customer Service, contact the place of purchase to arrange for replacement parts.
PARTS & ASSEMBLY SHEET
Fixture Name: Waverly 3500-SF AB
Fig 2 ASSEMBLING THE FIXTURE as Chain hung (Fig.2)
1. Place Shade (Q) onto the threads of
Threaded Stem (P) into the coupling at center
of Fixture Body (R).
2. Thread the Top Loop (J) onto the Threaded
Stem (P1)and(P). Hand-tighten until the Top
Loop is snug.
3. Measure to determine the correct number of
links needed for proper hanging height. Use a
pair of pliers to open one link of Chain (K). Then
remove and discard the excess chain.
4. Use Chain Connector (L) to attach one end of
the chain to Top Loop (J) and close the chain
connector.
5. Feed the fixture wires through the chain (every
three links) and pull the wires until taut.
6. Slip Canopy Loop Collar (H) over the chain,
then do the same with the Canopy (G).
9. To complete the installation, use the other
chain connector to attach the other end of
the chain to the Canopy Loop (F) and close
the chain connector.
10. Make sure that the weight of the
chandelier will be supported by the chain, not
the electrical wire.
* You may now install the fixture.
Note: Complete these remaining steps after
the fixture is hung.
11. Install the light bulbs (not provided) in
accordance with the fixture's specifications.
(DO NOT EXCEED MAXIMUM WATTAGE RATING )