Cabletron Systems 2E48-27R - Manual (Page 29)

Installing the Device
2E48-27R/2E49-27R User’s Guide 3-5
Installation
Rack mounting the 2E4X-27R involves the following:
• Attaching the strain-relief bracket
• Rack mounting the 2E4X-27R (attaching the mounting brackets and
fastening the 2E4X-27R to the rack)
Attaching the Strain-Relief Bracket
Attach the strain-relief bracket to the front of the 2E4X-27R as follows:
1. Locate the strain-relief bracket and four 8-32 x 3/8-inch pan-head
screws in the rackmount kit.
2. Place the 2E4X-27R upside down (as shown in Figure 3-2 ) on a clean
flat surface. Then attach the strain-relief bracket to the bottom of the
2E4X-27R using the four 8-32 x 3/8-inch pan-head screws.
Figure 3-2 Attaching the Strain-Relief Bracket
!
CAUTION
Do not attempt to attach the strain-relief bracket with screws
other than the 8-32 x 3/8-inch screws included with the
2E4X-27R. Use of longer screws may damage the unit.
Strain-Relief Bracket
Screws (4)
23141-47
2E48-27R
26 25
RX TX
RX TX 24
RX TX 8
RX TX 16
RX TX 23
RX TX 7
RX TX 15
RX TX 22
RX TX 6
RX TX 14
RX TX 21
RX TX 5
RX TX 13
RX TX 20
RX TX 4
RX TX 12
RX TX 19
RX TX 3
RX TX 11
RX TX 18
RX TX 2
10
17
RX TX 1
RX TX 9
RX TX
COM
RESET
PWR
CPU