Example – Cabletron Systems 2E48-27R User Manual
Page 134
Chapter 5: Local Management
5-88
2E48-27R/2E49-27R User’s Guide
Example:
atm_stp_state:
Syntax:
atm_stp_state [STATE]
Description:
The atm_stp_state command allows the user to
enable, disable, or check the status of the
Spanning Tree Algorithm on all ATM
interfaces. The user must specify the STATE
option as enable, disable, or status.
Options:
enable, disable, status
Example:
NOTE
The atm_stp_state command is only available if an
HSIM-A6DP is installed in the module (e.g.,6E13X-25). This
command allows the user to enable, disable, or check the
current status of the Spanning Tree Algorithm on all ATM
interfaces.
-> link_trap status
Port 1 is ENABLED
Port 3 is ENABLED
Port 2 is DISABLED
Port 4 is ENABLED
-> link_trap disable 2
-> link_trap disable all
-> link_trap status 3
LINK TRAP STATUS:
Link traps have been DISABLED on port 2
Link traps have been DISABLED on all ports (1-24)
Link traps are ENABLED on port 3
2314-78
-> atm_stp_state status
Atm Stp is Enabled
-> atm_stp_state disable
-> atm_stp_state enable
2314-79