Cabletron Systems 2E48-27R - Manual (Page 150)

Appendix C: Optional Installations and Mode Switch Bank Settings
C-6 2E48-27R/2E49-27R User’s Guide
• Switch 7 – Clear NVRAM. Changing the position of this switch resets
NVRAM on the next power-up of the device. All user-entered
parameters, such as the IP address, device names, etc., are reset to the
factory default settings. Once the 2E4X-27R resets, you can either use
the factory default settings or reenter your own parameters.
• Switch 8 – Reset Password/Community Names. Changing the position
of this switch clears user-entered passwords stored in NVRAM, and
restores the factory default passwords on the next power-up of the
device. Once the 2E4X-27R resets, you can either use the factory
default settings or reenter your own passwords.
NOTE
Do not change the position of switch 8 unless it is necessary to
reset the module super-user configured passwords to their
factory default settings.