Cabletron Systems 2E48-27R - Manual (Page 130)

Chapter 5: Local Management
5-84 2E48-27R/2E49-27R User’s Guide
Example:
ping:
Syntax: ping [IP address]
Description: The ping command generates an outbound ping
request to check the status (alive/not alive) of a
device at a specified IP address.
Options: Not Applicable
Example:
reset:
Syntax: reset
Description: This reset command initiates a hardware reset
of the device. The reset command initializes the
CPU processor, runs the onboard diagnostics,
and restarts the software image, which restores
the user configuration settings from NVRAM.
The user will be queried to confirm the reset
command to ensure against unwanted resets.
-> netstat -i
Interface + Description
# 1 (ethernet -csmacd)
# 2 (ethernet - csmacd)
# 3 (ethernet - csmacd)
# 4 (ethernet - csmacd)
MTU
1514
1514
1514
1514
MAC Addr
0x00 0x00 0x1d 0x07 0x50 0x0e
0x00 0x00 0x1d 0x07 0x50 0x0f
0x00 0x00 0x1d 0x07 0x50 0x10
0x00 0x00 0x1d 0x07 0x50 0x11
Admin
up
up
up
up
-> netstat -r
05141-70
Speed
10000000
10000000
10000000
10000000
Oper
up
up
up
up
Destination
# Default Route
# 134.141.0.0
# 134.141.0.0
Next-hop
DirectConnection
DirectConnection
DirectConnection
Interface
1
2
3
-> ping 122.144.40.10
122.144.40.10 is alive
05141-71