GME TX3520 - Manual (Page 24)

PA G E 2 4 I n s t r u c t I o n m A n uA l t X 3 5 1 0 / t X 3 5 2 0 / t X 3 5 4 0
Deleting an RX-Only channel
to delete an rX-only channel;
1. Enable the channel Editor.
2. select the channel you wish to delete.
3. Press and hold the MENU key until the radio beeps.
4. rotate the Channel knob all the way to the left (or press
repeatedly) until –oFF– is displayed.
5. Press and hold the Channel knob (or LVL
PRI key) to store
the new setting.
6. switch the radio oFF then on again to restore
normal operation.
the deleted channel will no longer be visible.
Displaying the RX-Only channel’s frequency or
Alpha label
By default the radio displays the signal strength meter to the
left of the channel number. You can configure the display to
show the Frequency or the Alpha name of the
selected channel.
Before starting, ensure the radio is in the numeric mode (press
F then ALPHA so that ‘numEr’ is displayed).
1. select an rX-only channel (the following menu option is
only available when an rX-only channel is selected).
2. Press and hold MENU until the radio beeps.
3. Briefly press MENU repeatedly until S-MET appears.
4. rotate the Channel knob to the right (or press ) until
ALPHA is displayed.
5. Press the PTT to exit the Menu.
the radio will now display the channel frequency to the left of
the channel number whenever an rX-only channel is selected.
To display the channel’s ALPHA label
Briefly press F then ALPHA. ‘AlPHA’ will appear briefly then
the channel’s Alpha label will be displayed to the left of the
channel number. If the Alpha label is blank, then an Alpha
label has not yet been set for this channel. Follow the steps
right to enter your preferred Alpha label.
Adding names to your RX-Only channels
NOTE: You do not need to activate the channel editor to
make changes to rX-only channels that have already
been programmed.
1. select an rX-only channel. the channel frequency will be
displayed to the left of the channel number.
2. Press F then ALPHA to switch to Alpha mode. ‘AlPHA’ will
be displayed briefly.
3. Press and hold the MENU key until the radio beeps. the
cursor will flash in the left character position.
4. rotate the Channel knob (or press or ) to select the
required character. Press the Channel knob (or LVL
PRI key)
to advance to the next character position.
5. When the desired name is displayed, press and hold the
Channel knob (or LVL
PRI key) to store the name.
6. Briefly press the PTT to exit and return to normal operation.
RX-Only channel frequency (458.325 mHz)
RX-Only channel label
When viewing rX-only channels, briefly press F then ALPHA
at any time to toggle between the channel frequency and the
Alpha name.
CONFIGURaTION MENU
the configuration menu controls preset functions in the radio.
to access the menu, press and hold the MENU key until a beep
is heard. selected menu options are displayed to the left of the
channel display. Briefly press the Menu key to step through the
available menu options. rotate the Channel knob (or press