GME TX3520 - Manual (Page 18)

PA G E 1 8 I n s t r u c t I o n m A n uA l t X 3 5 1 0 / t X 3 5 2 0 / t X 3 5 4 0
Call acknowledge
If your selcall transmission is successful, the radio you called
should respond with an ‘acknowledge’ signal - usually two
quick beeps. this will confirm to you that the radio you called
is now alerting its user to your signal.
Selcall memories
Your radio is fitted with one ‘call’ memory and 10 user
programmable selcall memories labelled ‘C0’ to ‘C9’ there is
also one additional location labelled ‘Id’.
memory locations ‘C0’ to ‘C9’ are for storing frequently called
selcall Idents. the additional location labelled ‘Id’ contains
your radio’s own selcall Ident. You should only select this
memory location if you need to change your radio’s factory
programmed selcall Ident.
To store a Selcall Ident in memory
1. Briefly press the CALL button. is displayed along with
the last sent or received selcall Ident.
2. rotate the Channel knob clockwise (or press ) to select
the required Ident memory location ‘C0’ to ‘C9’ (or select
‘Id’ to change your radios own selcall Ident). If an AlPHA
label is displayed you will need to press F then ALPHA to
switch to numeric mode.
3. Press and hold the Channel knob (or LVL
PRI key) until the
radio beeps. the right-hand digit of the selcall Ident
will flash.
4. rotate the Channel knob (or press or ) to select the
required number in the flashing digit position.
5. Briefly press the Channel knob (or LVL
PRI key) again to
select the next digit position.
6. repeat steps 4 and 5 to enter all 5 digits as required.
7. now press and hold the Channel knob (or LVL
PRI key).
the entire Ident will flash for a few seconds then the radio
will beep as the new Ident is stored.
e.g. Programming Call Memory C5
Recalling Selcall Idents
1. Briefly press the CALL button. is displayed along with
the last sent or received selcall Ident.
2. rotate the Channel knob (or press or ) to select the
required Ident memory in locations ‘C0’ to ‘C9’.
3. Press and hold the CALL button to send the Ident.
Naming your Selcall Idents
Your radio allows you to label each selcall Ident using a 5
character name to make it easier to identify callers. If an
incoming selcall matches one of those in your radio’s memory,
the label can be displayed instead of the selcall Ident.
NOTE: Before adding an AlPHA label to a selcall Ident, you
must first store the required Ident in memory as described left.
1. Briefly press the CALL button. will be displayed along
with the last sent or received selcall Ident.
2. rotate the Channel knob (or press or ) to select the
required Ident memory in locations ‘C0’ to ‘C9’.
3. Briefly press the F then ALPHA to select the AlPHA mode.
ALPHA will be displayed briefly.
4. If the AlPHA label is empty, ‘- - - - -’ will be displayed,
otherwise it will display the last AlPHA label programmed
into that memory.
5. Press and hold the Channel knob (or LVL
PRI key) until the
radio beeps. the left-hand position of the Alpha label
will flash.
6. rotate the Channel knob (or press or ) to select the
required character in the flashing position then briefly press
the Channel knob (or
LVL
PRI key) again to select the
next position.