Select the clock set mode, Set the time & am or pm, Set the month, day & year – Philips VR650 User Manual
Page 9: Start the clock, To reset the clock, Set the clock, Set the clock 9 t, Make sure
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Set the Clock 9
T
o
set your VCR to the present day and time, follow steps 1-4 below. Once set, your VCR (Video Cassette Recorder)
will maintain the time in its internal clock, and will make timer recording possible.
I
Make sure... |---------------------------------------
• your VCR and TV are connected and turned on.
• the VCR indicator says “VCR”.
• to make each entry within 10 seconds, otherwise the VCR will exit
the Clock Set mode and you will have to start over.
Select the Clock Set Mode
Press the MENU button. Then press the 5
button to select “CLOCK SET’ from the
menu screen.
Set the Time & AM or PM
I First, press two NUMBER buttons for the hour, then two NUMBER
buttons for the minutes, and finally press “1” for AM or “2” for PM.
For example, for 10:30 PM, press the NUMBER buttons 1-0,3-0,2.
When setting the clock for the first time, entries that do not
match the VCR’s internal calendar will cause a “?” to appear.
Always enter “0” before any single-number entries.
To make corrections, press the CLEAR button repeatedly to move
back to an item then enter the correct number.
Set the Month, Day & Year
Press two numbers for the month, two
numbers for the day, and two numbers for
the year.
For example, for July 1,1994, press the
NUMBER buttons 0-7,0-1,9-4.
TIME 10 JO PM
MONTH
TO CORRECT PUSH CLEAR
TO END PUSH MENU
Start the Clock
TIME 10 30 PM
DATE 07/01/94
FRI
TO CORRECT PUSH CLEAR
TO END PUSH MENU
1
Press the MENU button.
Clock starts and the screen returns to the program you were on.
To display the time, press the STATUS button.
To Reset the Clock
Press the MENU button. The TV and VCR must be on and the VCR
in the “VCR” mode. The menu screen will appear. Press the
NUMBER 5 button and follow the clock set
guide to re-enter the new date and time.
TO SELECT PUSH NO SHOWN
1 PROGRAM
2VCRSETUP
3 TUNER SET UP
4 INPUT SELECT
5 CLOCK SET
6 DAYLIGHT SAV TIME
TO END PUSH MENU
Power failures can cause you to lose your clock setting placed in the
VCR’s memory. Should this happen, repeat steps on pages 8 and 9
before doing anything else.
Your VCR should now be properly set-up.
Go to the next page and try playing a tape.