Selept channel 3 or 4, At the tv, Chpose your language – Philips VR650 User Manual

Page 8: Sefting the vcr’s tuner, Re-setting your vcr’s tuner, 8 hook up your vcr (conf d) 2, Turn on your vcr, Back of vcr, Make sure

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

8 Hook Up Your VCR (conf d)

Selept Channel 3 or 4

Back of VCR

Set the CH3/CH4 switch on the back of the VCR to channel

3 or 4. To operate the VCR with your TV, set your TV to the
same channel. For example, if your switch is set to chaimel 3
(CH3), turn your TV to channel 3.

To avoid local interference, the CH3/CH4 switch position you

choose should correspond to the local TV channel that is not

used or least used.
If both are used, select the channel that gives you the best
picture when playing a tape.

—

----------------

3 ilillllllllllMll !

1 II

т’т

,(fe

5 =1^0,

____________________________________ / X___________

Now, turn ON the VCR’s power to see if you have made the right connections.

Turn On Your VCR

Make sure

the batteries are loaded in the remote control and the connections

have been completed before continuing to the steps below.

At the TV

I Turn the TV on. Set the TV to the same chaimel as the switch on

the back of the VCR (CH3/CH4).

Chpose Your Language

TO SELECT PUSH NO. SHOWN

1 ENGLISH

2 ESPAÑOL

MAKE SELECTION OR

PUSH MENU TO CONTINUE

Press the VCR POWER button.

• The VCR (Video Cassette Recorder) Power will

come on.

The language select menu appears, asking you

' whether you prefer to have messages displayed

on your TV screen in English or in Spanish.

Press the NUMBER 1 button if you want English.
Press the NUMBER 2 button if you want Spanish.
Press the MENU button to continue to the next step.

• To change your selection later on, see the instructions on page 13.

[ON]

Sefting the VCR’s Tuner

—

AUTO

SET

PROCEEDING

PLEASE WAIT

Press the VCR CH(annel) UP button to start
automatic tuner setting.

• “AUTO SET PROCEEDING, PLEASE WATT”

will be displayed on the TV screen. If you made

all connections properly, the local channels that
are receivable in your area will be automatically

placed in your VCR’s tuner.

(If the tuner has already been set, press the STOP button.)

• When completed, “AUTO SET COMPLETED” will be displayed

and the VCR will tune in to the lowest receivable channel.

• If proper antenna or cable connections were not made, “NO TV

SIGNALS” will be displayed. Please make connections and press

the VCR CH(annel) UP button again.

Now, turn to the next page and set the
VCR’s clock