Philips FW-C500 - Manual (Page 50)

Clock/Timer
2
Press CD, TUNER or TAPE to select the
desired source,
• Make sure the music source has been prepared.
CD - Load the disc(s).To start from a specific
track, make a program (refer to "CD Operation -
Programming the disc tracks").
TUNER - tune to the desired radio station.
TAPE - load the prerecorded tape into tape
deck 2.
3
Press or
►►
on the system repeatedly to set
the hour for the timer to start,
4 Press N or P-l on the system repeatedly to set
the minute for the timer to start.
5
Press CLOCK*TIMER to store the start time.
"i
It'lLR
DM" will be displayed and followed
by the set timer
¡( '■ "
and then the selected
source.
"♦ TIMER 0 will remain on the display.
• At the preset time, the selected source will play.
To exit without storing the setting
• Press ■ on the system.
Notes:
- If the selected source (CD or TAPE) is not
available when preset timer is reached, TUNER will
be selected automatically.
- During timer setting, if no button is pressed
within 90 seconds, the system will exit timer setting
mode automatically.
To deactivate theTIMER
• Press TIMER ON/OFF on the remote control,
“> The display will show "Dn'M'L'DL" and
timer
0
will disappear from the display.
Sleep Timer Setting
The sleep timer enables the system to switch to
Standby mode automatically at a preset time.
Press SLEEP on the remote control repeatedly
to select a preset time.
The selections are as follows (time in
minutes):
ic —► on u r r n . , ПГГ I C
lo _ILJ I . D ^ UL-I U l I ^ l-J . , .
-> "LiLLLP ii or "uf Г" will be displayed, "t' id’
is the time in minutes,
When you reach the desired length of time, stop
pressing the SLEEP button.
SLEEP will appear on the display, except for
"иГГ" mode.
^ The Sleep Timer is now set. Before the
system switches to standby mode, a countdown
of 10 seconds will be displayed.
"Cl г г о qii
:тр
-LLP'"
While SLEEP mode is activated
To check the remaining length of time
Press SLEEP once.
To change the preset sleep timer
Press SLEEP twice,
-> The display will show the remaining time
followed by the sequence of sleep timer options.
To deactivate the Sleep Timer
Press SLEEP repeatedly until "01- D" is displayed,
or press the STANDBY ON button.
To activate theTIMER
Press TIMER ON/OFF on the remote control.
The last set timer information will be shown
for a few seconds and
timer
0) will appear on
the display.
26