Philips FW-C500 - Manual (Page 45)

Tape Operation/Recording
To change the playback mode
Press AUTO REPLAY repeatedly to select the
different playback modes,
IPCPLRy"( Z)or 'UMCPwill
appear on the display.
AUTO REPLAY ., .the tape will rewind
automatically at the end of
playback and replay again. It will
replay up to a maximum of 20
times until you press ■ .
ONCE................the tape will playback the
selected side once and then stop.
To rewind or fast forward during
playback
Press and hold or ►► until the desired
passage is reached, then release.
-> The tape continues playing.
The tape will stop automatically at the end of
the rewinding or fast forwarding.
^ During searching, the sound is reduced to a
low volume.
To rewind or fast forward when playback
is stopped
Press or
Press ■ when the desired passage reached.
To reset tape counter number
When in stop mode, press ■ .
-> "ir I uuu" or'TF'iP uuG''will be displayed.
Notes:
-
During rewinding or fast forwarding of a tape, it
is also possible to select another source (CD,
TUNER orAUX, for example).
-
The tape counter will automatically set to zero
after detecting end of tape.
General Information on
Recording
For recording, use only tape of I EC type I
(normal tape) or lEC type II (CrO^).
The recording level is set automatically,
regardless of the position of the Volume, VAC,
DSC and so forth.
The tape is secured at both ends with leader
tape. At the beginning and end of the tape,
nothing will be recorded for six to seven
seconds.
To prevent accidental recording, break out the
tab on the left shoulder of the tape side you
want to protect.
OIDEiO
STJ
If
"uhlCfh' TFIPf''
is displayed, the protection
tab has been broken. Put a piece of clear
adhesive tape over the opening. Do not cover
the CrOj tape detection hole when covering the
tab opening.
23