Philips FW-C500 - Manual (Page 17)

General Information
This system complies with the FCC rules.
Part 15 and with 21 CFR 1040.10.
Operation is subject to the following two
conditions;
- This device may not cause harmful
interference, and
- This device must accept any interference
received, including interference that may
cause undesired operation.
Environmental Information
All unnecessary packaging has been omitted. We
have tried to make the packaging easy to
separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene (bags,
protective foam sheet).
Your system consists of materials which can be
recycled and reused if disassembled by a
specialized company. Please observe the local
regulations regarding the disposal of packaging
materials, exhausted batteries and old
equipment
Acknowledgement
Energy Star
As an ENERGY STAR®
Partner Philips has
determined that this product
meets the ENERGY STAR®
guidelines for energy efficiency
(for model
FW-C550 only).
Supplied accessories
- Remote control
- Batteries (two AA size) for remote control
- AM loop antenna
- FM wire antenna
- AG power cord
Safety Information
Before operating the system, check that the
operating voltage indicated on the typeplate (or
the voltage
indication
beside the voltage
selector) of your system is identical with the
voltage of your local power supply. If not,-please
consult your dealer
Place the system on a flat, hard and stable
surface.
Place the system in a location with adequate
ventilation to prevent internal heat build-up in
your system. Allow at least 10 cm (4 inches)
clearance from the rear and the top of the unit
and 5 cm (2 inches) from each side.
Do not expose the system, batteries or discs to
excessive moisture, rain, sand or heat sources
caused by heating equipment or direct sunlight
If the system is brought directly from a cold to a
warm location, or is placed In a very damp room,
moisture may condense on the lens of the disc
unit inside the system. Should this occur the GD
player would not operate normally. Leave the
power on for about one hour with no disc in the
system until normal playback is possible.
The mechanical parts of the set contain self-
lubricating bearings and must not be oiled or
lubricated.
When the system is switched to Standby
mode, it is still consuming some power.
To disconnect the system from the
power supply completely, remove the AC
power plug from the wall socket.
tl
tl
b(