Philips FW-C500 - Manual (Page 27)

Basic Functions
o #
o o o”o
© '© ©
© o o
6 O
o © o'“
Gr0"i+)
C© CtD
0)
I
IMPORTANT!
Before you operate the system, complete
the preparation procedures.
Plug and Play
Plug and Play allows you to store all available
radio stations automatically.
If Plug and Play has not been installed
1
When you turn on the system, "PiLlhu
IMBiflLL -Pf©55 PLRT will be displayed.
2
Press PLAY ► on the system to start
Installation.
"1I'J5 I rlLL" will be displayed and followed by
"I UIMPP" and then "FILIfQ".
-> PROG will Start flashing.
^ The system will search for all radio stations
on the FM band, then the AM band.
-> All available radio stations with sufficient signal
strength will be stored automatically.
-> The system will stop searching when all the
available radio stations are stored or when the
memory for 40 preset radio stations is used.
-> The last preset radio station will play when
Plug and Play Is completed.
To reinstall Plug and Play
1
In Standby or Demonstration mode, press and
bold PLAY ► on the system until "nLI I LI
ilML I FILL - F'FLLib f-'LF'Ll" is displayed.
2
Press PLAY ► again to start Installation.
-> All previously stored radio stations will be
replaced.
To exit without storing the Plug and Play
• Press ■ on the system.
Notes:
- When the power is turned on, the disc tray may
open and close to initialize the system.
- If you do not complete Plug and Play installation,
Plug and Play will be reinitiated the next time you
turn on the power.
- If no stereo frequency is detected during
Plug and Play, "CFILL L IfM fL MMf I" will be
displayed.
- During Plug and Play, if no button is pressed
within 15 seconds, the system will exit Plug and
Play mode automatically.
Demonstration mode
The system has a demonstration mode that
shows the various features offered by the system.
To activate the demonstration
• In Standby mode, press and hold DEMO
STOP ■ on the system until "jj'LI''lu uM" Is
displayed.
^ The demonstration will begin.
To deactivate the demonstration
• Press and hold DEMO STOP ■ on the system
until "J j LLI u u FF" is displayed.
The system will switch to Standby mode.
Note:
- Even if you remove the AC power cord and
reconnect it to the wall socket, the demonstration
will remain off until you activate it again.
13