Philips FW 72C - Manual (Page 23)

CLOCK
View Clock
You can view the clock (if it is set) at standby or any
source mode. It will be displayed for about 7 seconds.
• Press CLOCK*TIMER briefly.
AM" (tbe current time) will be displayed.
— " - - - -" will be displayed if the clock is not set.
Clock setting
The clock is set in 12-hour mode, e.g. lc':lJO AM or
lc':iJlJ PM. Before setting the clock, you must be at the
View Clock mode.
1 Press CLOCK*TIMER to select clock mode.
" !c DO AM" or the current time starts flashing.
- " « , ► ► , ! ◄ , H " light up.
2 Set the hour with ■ ^■ ^or^^.
3 Set the minute with N o r H .
4 Press CLOCK*TIMER again to store the setting.
-*■ The clock starts running.
• To exit without storing the setting, press STOP ■ .
Notes:
- During clock setting, if no button is pressed within 90
seconds, the system will exit clock setting mode
automatically.
- When power interruption occurs, the clock setting is
erased.
Timer Setting________________________
• The system can switch on to CD, TUNER or TAPE 1
mode automatically at a preset time. It can serve as an
alarm to wake you up. After half an hour from the
preset time, the system will return to the standby
mode if no button is pressed.
• Before setting the timer, make sure the clock is set
correctly.
• The timer has to be reset or start again for each
subsequent preset time.
• The volume of the timer will be at the last setting
before the system is switched to standby mode.
1 Press and hold CLOCK*TIMER for more than 2
seconds to select timer mode.
-* "ui J lc':00 AM" or the last set timer starts
flashing. The TIMER flag will be displayed.
The last selected source is lighted while other
available sources are flashing.
— ^ H _ ► ! , ■ " light up.
2 Press CD, TUNER or TAPE to select the desired
source.
• Before selecting CD or TAPE mode, make sure that a
CD or tape is loaded respectively in the CD tray or tape
deck 1.
3 Press ◄◄ or ►► to set the hour for the timer to start.
TIMER
4 Press N or ►! to set the minute for the timer to start.
5 Press CLOCK*TIMER again to store the start time
and the selected source.
The TIMER is now set.
-* The TIMER flag remains on the display.
• To exit without storing the setting, press STOP ■ .
• At the preset time, the TIMER will be activated.
The selected source will be played.
The TIMER flag disappears from the display.
Notes:
- During timer setting, if no button is pressed within 90
seconds, the system will exit timer setting mode
automatically.
“ If the source selected is TUNER, the last tuned
frequency will be switched on.
- If the source selected Is CD, playback will begin with
the first track of the last selected disc. If the CD trays
are empty, the TUNER will be selected instead.
- If the source selected is TAPE I, and if the preset time
is reached during high speed dubbing, the TUNER will
be selected Instead.
To cancel the TIMER
1 Press CLOCK*TIMER for more than 2 seconds.
2 Press PAUSE II to cancel the timer.
THNCEL" will be displayed.
The TIMER flag disappears from the display.
To start the TIMER again (for the same time)
1 Press CLOCK*TIMER for more than 2 seconds.
2 Press CLOCK*TIMER again to store the start time
and the selected source.
23