Tape, Recording, Recording -22 – Philips FW 72C User Manual
Page 21: Tape aux recording, Selecting external equipment, One touch recording
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TAPE
AUX
RECORDING
2
Press STOP ■ to stop rewind or fast forward.
During playback
• Press and hold or ► ► respectively until the desired
passage is located.
-* During searching, the sound is reduced to a low
volume.
-*• When you release or the tape continues
playing.
Notes:
- During rewinding or fast forwarding, it is possible to
select another source (e.g. CD, TUNER or AUX ).
~ Check and tighten slack tape with a pencil before use.
Slack tape may get jammed or may burst in the
mechanism.
- C-120 tape is extremely thin and may be deformed or
damaged easily. It is not recommended for use in this
system.
- Store the tapes at room temperature and do not put
them too close to a magnetic field (for example,
transformer, TV or loudspeaker boxes).
Selecting External Equipment___________
If you have connected the audio out terminals of the
external equipment (TV, VCR, Laser Disc or DVD player) to
the AUX ll'J terminals, you can hear the sound from the
system.
• Press AUX to select the external mode.
RLI-" will be displayed.
Note:
All the sound control features (e.g. DSC, DBB, etc.) are
available for selection.
Notes:
- For recording, use only tape of lEC type I (normal tape)
or lEC type II (Chrome).
-
The tape Is secured at both ends with leader tape. At
the beginning and end of tape, nothing will be
recorded for six to seven seconds.
-
The recording level is set automatically, regardless of
the position of VOLUME or DBB.
- To prevent accidental recording, break out the tab on
the left shoulder of the tape side that you want to
protect.
- I f ' С Н Е С И T Н Р С " is displayed, the protection tab
has been broken. Put a piece of clear adhesive tape
over the opening. Do not cover the CrO^ tape detection
hole when covering the tab opening.
One Touch Recording__________________
• For One Touch Recording, as soon as you press
RECORD,
the current source will be recorded on tape
deck 2.
1 Load a blank tape in tape deck 2.
2
Press RECORD to start recording.
— The RFC flag starts flashing.
3
Press STOP ■ to stop recording.
Note:
- When you press RECORD at TAPE mode, 'GO L C C T
u T H C P S u i l R C C " will be displayed. One Touch
Recording is not possible at TAPE mode.
21