Philips FW 72C - Manual (Page 22)

RECORDING
Recording from othor sources loniym ape
deck 2)_______________________________________
1 Press TAPE to select tape deck 2.
2 Load a blank tape into tape deck 2 with the open side
downward.
3 Press REVERSE MODE to select the playback mode
( ~Z. or ~I 2 > )•
4 Press CD, TUNER or AUX
• Start playback of the selected source.
5 Press RECORD to start recording.
The REC flag starts flashing.
6 Press STOP ■ to stop recording.
Notes:
- Only ^ or mode is available during recording.
- During recording, it is not possible to listen to another
source.
Dubbing tapes (from tape deck 1 to tape deck2)
1 Press TAPE to select tape deck 2.
2 Load the prerecorded tape into tape deck 1 and a
blank tape into tape deck 2.
-* Make sure that the tape in tape deck 1 has its full
spool to the left.
3 Press DUBBING once for normal speed dubbing or
twice within 2 seconds for high speed dubbing.
" i J lj P i IRL" (normal speed) or T R S T " (high speed)
will be displayed and then followed by
"T)i |■ o^эт^ iri"
UUUJJiMU .
The HSD flag appears on the display for high speed
dubbing.
• Dubbing will start immediately.
The REC flag starts flashing.
4 Press STOP ■ to stop dubbing.
Notes:
- At the end of side A. flip the tapes to side B and
repeat the procedure.
- Dubbing of tapes is only possible from tape deck 1 to
tape deck 2.
- To ensure good dubbing, use tapes of the same length.
- During high speed dubbing in Tape mode, the sound is
reduced to a low volume.
- You can switch to other source while dubbing.
CD Synchro Start Recording
1 Load a blank tape into tape deck 2 and a disc into the
disc tray.
2 Press CD to select CD mode.
• You can program the tracks in the order you want them
to be recorded (see Programming Tracks). If not, the
tracks are recorded according to the selected disc.
3 Press RECORD to start recording.
The REC flag starts flashing.
• CD will start playback automatically.
4 Press STOP ■ to stop recording.
22