Philips FW 72C - Manual (Page 17)

CD
2 Replace the discs in the left and right disc trays.
• If you press DISC CHANGE again during playback,
the CD will stop playing.
The CD carousel tray will rotate until the inner tray
is at the right hand side and is ready for changing.
3 Press OPEN'CLOSE to close the CD compartment.
Selecting a desired track_______________
Selecting a desired track at the stop mode
1 Press PREV N or NEXT ► ! until the desired track
appears on the display.
2 Press PLAY ► to start playback.
The selected track number and elapsed playing
time appear on tbe display.
Selecting a desired track during playback
1 Press PREV N or NEXT N until tbe desired track
appears on the display.
The selected track number and elapsed playing
time appear on the display.
• If you press PREV W once it will skip to the beginning
of the current track and play the track again.
Searching for a particular passage
during playback______________________
• Press and hold or ► ► until the desired passage is
located.
The volume will be reduced.
• Playback returns to normal when « or ► ► is
released.
Programming Tracks
Programming tracks of a loaded CD is possible in the stop
mode. The display will indicate the total tracks stored in
the program. Up to 40 tracks can be stored in the memory
in any order. When 40 tracks are stored and you attempt
to store another track, the display will show "PRuGRRif
n I I I " I uuu .
1
Load the desired discs in the disc trays.
2 Press PROGRAM to start programming.
The PROGRAM flag starts flashing.
3 Press the CD (CD 1 •2*3) to select the desired disc.
4 Press PREV !◄ or NEXT H to select the desired
track.
5 Press PROGRAM to store the track.
• Repeat steps 3to 5to store other discs and tracks.
6 Press STOP ■ once to end programming mode.
The total number of tracks programmed and total
playing time appear on the display.
Notes:
-
If the total playing time is more than "S S •' 5 S'" or if
one of the programmed tracks has a number greater
than 30, then
" appears in the display instead
of the total playing time.
- During programming, If no button is pressed within 20
seconds, the system will exit program mode
automatically.
Playing the program
1 Press PLAY ► to start program playback.
-* "Pi_RR PPuGPRi'l" will be displayed.
The track number and elapsed playing time of the
current track will appear on the display.
• If you press REPEAT during program playback, the
current track will be played repeatedly.
The REPEAT and PROGRAM flags will be displayed.
2 Press STOP ■ to stop program playback.
Note:
- If you press any of the 3 CD DIRECT PLAY buttons, the
system will play the selected disc or track and the
stored program will be ignored temporarily. The
PROGRAM flag will also temporarily disappear from
the display and then reappear, when the playback for
the selected disc ends.
Reviewing the program________________
Reviewing of the program is only possible in the stop mode.
• Press PREV W or NEXT ► ! repeatedly to review the
programmed tracks.
• Press STOP ■ to exit review mode.
Erasing the program (in the stop mode)
• Press CLEAR on the system.
"RREIT will be displayed.
'Tinr^ n rr
j i x f l l I I „ I „ L - I
Note:
The program will be erased when the system is
disconnected from the power supply. If the CD
carousel is opened, the tracks belonging to the outer
two trays will be erased and the display will show
17