Philips FW 72C - Manual (Page 20)

TAPE
5
*^
Loading a tape
• Press OPEN.
• The tape deck door opens.
• Load the tape with the open
side downward and the full
spool to the left.
• Close the tape deck door.
Tape Playback
1 Press TAPE to select TAPE mode.
-* "ТПРЕГ i" or "ТПРС c?" will be displayed.
• Press TAPE again to select either tape deck 1 or tape
deck 2.
2 Load the tape into the desired tape deck.
3 Press PLAY ► to start playback.
3a (For Tape Deck 2 only)
Press SIDE A*B (or PLAY ► again on the remote
control) to switch playback between sides A and B.
-* The ◄ or ► (back or front) flag appears on the
display, depending on the side selected.
3b (For Tape Deck 2 only)
Press REVERSE MODE to select the different type of
playback mode (see auto reverse playback).
4 Press STOP ■ to end playback.
Notes:
- It Is necessary to start playback on tape deck 2 before
changing side A and B.
- When the tape has stopped playing, the system will
switch to the standby mode automatically after 15
minutes if no button is pressed.
Auto Reverse Playback (only on tape deck 2)
• Press REVERSE MODE to select the different
playback modes.
^........................ recording or playback on one side of
the tape. The tape stops at the end of
one side.
.................recording or playback on both sides of
the tape. The tape then stops.
...............continuous playback on both sides of
the tape up to a maximum of 20 times
per side unless you press STOP ■ .
Rewind/Fast Forward (only on tape deck2)
At the stop mode
1 You can rewind or fast forward the tape by pressing
« or ► ► respectively.
"«< or »>" will be displayed depending on which
button is pressed.
The tape will stop automatically at the end of the
rewinding or fast forwarding.
20