Futaba 8SSAP - Manual (Page 6)

•CONTENTS AND RATINGS
Ratings and specifications are subject to change without prior notice.
Model
Transmitter
Receiver
Servos
Switch
Nicd battery
Accessories
FP-8SSAP
FP-T8SSAP x 1 with module FP-TF-FM
FP-R118GPx 1
FP-S130x4
SWH-5x 1 (R4-SWJx1»
N R - 4 J x 1
Battery charger, landing gear adaptor, DSC cord, CHG adaptor, DSC-CHG cord,
servo tray, frequency flag, spare horn, screws
Transmitter FP-T8SSAP Receiver FP-R118GP
Operating system
Transmitting
frequency
Modulation
Power requirement
Current drain
Chosen
band
Single-stick, 8 channels for
F3A pattern
50/53MHz BANDS
72/75MHz BANDS
53MHz ~ 72MHz
Frequency change to any of
above bands is possible by
merely changing RF module.
PCM,FM
9.6V 8/500mAH internal
Nicd battery
250mA
Receiving frequency
Intermediate
frequency
Power requirement
Current drain
Dimensions
Weight
Receiving range
50/53MHz BANDS [chosen
72/75MHz BANDS (band
455kHz
4.8V Nicd battery (shared
with servo)
42mA (4.8V reception)
2.23 x 1.65x0.94 in
(57 x 52 x 24mm)
1.85oz (53g)
500m on the ground
1000m in the air
When FP-T8SSAP used.
(At the best radio wave con-
dition of environment)
4
Servo FP-S130 Landing Gear Servo FP-S130G (Option)
Control system
Operating angle
Power requirement
Current drain
Output torque
Operating speed
Dimensions
Weight
1520 +pulse width control,
uS.N
One side 45° or greater
including trim)
4.8V (shared with receiver)
5mA (at idle)
55.6oz.in (4kg-cm)
0.24 sec/60°
1.52 x 0.77 x 1.36 in
(38.5 x 19.5x34.5mm)
1.47oz(42g)
in-
Control system
Operating angle
Power requirement
Current drain
Output torque
Operating speed
Dimensions
Weight
+pulse width control
Rotary approx 160°
4.8V (shared with receiver)
8mA (at idle)
65.3oz.in (4.7kg-cm)
0.34 sec/60°
1 . 5 2 x 0 . 7 7 x 1.36 in
(38.5 x 19.5x34.5mm)
1.48oz (42g)
Battery Charger FBC-8B(2) Receiver Servo Nicd Battery NR-4J
Input voltage
Output
: 120VAC,50/60Hz
: TX side
9.6V/45mA
:RX side 4.8V/45mA
Voltage
Dimensions
Weight
: 4.8V, 4/500mAH
: 2.01 x 2.28 x 0.59 in
(51 x 58 x 15mm)
: 3.35oz (95g)