Futaba 8SSAP - Manual (Page 20)

ADJUSTMENTS AND FLIGHT TECHNIQUES
CHANNEL SELECT SWITCH
• This switch 48 selects the channel when setting
FS and HOLD functions. It also acts as the chan-
nel select switch for SERVO TEST function.
When switch 49 is set to RESET, the Channel
Select switch is used to designate the function
(ATV, FS, BFS memory, or ALL) to be cleared
by Buttons [46] and [47]. Note that the positions
on switch 48 have a different meaning when
the Function Select Switch is set on RESET.
This is summarized in the table below:
[48] Channel select switch
(48] Relationship among channel select switch
number, servo and reset.
No.
1.
2.
3.
4.
5.
6.
7.
8.
RESET &
TEST ALL
OFF
At switch [49] FS SELECT,
ATV. TESTA.B
Aileron
Elevator
Throttle
Rudder
Channel 5 switch (landing
gear)
Flaps
Channel 7 knob (spoiler)
Channel 8 lever (variable
pitch)
All the servos are
operated at servo
test.
Usually set to this OFF position.
At switch [49]
RESET
FS (fail safe)
ATV
BFS memory
FS, ATV, and BFS
memory are reset
simultaneously.
FUNCTION SELECT SWITCH
• This switch selects the function to be set (ATV,
FS, BFS memory) or test (A or B) to be per-
formed. It is also used in the RESET position to
clear ATV, FS, and BFS memory (in conjunction
with [46], [47], and 4 8 ) . Note: In RESET posi-
tion, the Channel Select Switch 48 is used to
designate the function(s) to be cleared.
[49] Function select switch
Fig. 23
• Normally set it to OFF.
1.FS ALL
Switch to this position when setting fail safe
for all channels, FS is described in the "HOW
TO USE FS" section.
2.FS SELECT
This position allows setting of fail safe and
hold as described in the "HOW TO USE
FS" section.
3.ATV
This position allows setting ATV as describ-
ed in the "HOW TO USE ATV" section.
4.TEST A
This position allows servo test A as described
in the "SERVO TEST" section.
5.TEST B
This position allows servo test B as described
in the "SERVO TEST" section.
6.BFS MEMO SET
Switch to this position when setting the BFS
release point as described in the "BATTERY
FS MEMORY SETTING" section.
7.OFF
Normally set to this position.
18