Futaba 8SSAP User Manual

Page 10

32 Transmitter RF module

• Change this module when switching frequen-
cy bands (50, 53, 72, and 75MHz).

34 Snap roll direction switch (R/L)

35 Snap roll direction switch (UP/DOWN)

•These switches control the direction of the
snap roll when the Snap roll switch 13 is used.

36 Fail safe set button

• This pushbutton is used when setting the Fail
Safe servo positions (FS instructions Page 24).

37 Back Cover

• Removal of this cover exposes the trimmer
panel. Remove as shown in Fig. 3.

Remove the back cover by pulling

these stoppers in the arrow direc-
tion.

Fig. 3

Fig. 2

Transmitter crystal

A temperature rise
at the RF module
section during use

is normal.

While pushing this tab to the

inside, pull the RF module
forward.

38 Trimmer Panel

•This panel contains switches, buttons, and trimmers for setting and adjusting the many versatile

transmitter functions. Use the small screwdriver supplied with the set for making adjustments.

Use the transmitter with fail-safe switches [7], [10], [29], [31], [32], and [33] in the INHIB (function off)

position until you become familiar with the set.

39 Trainer cord socket

Fig. 4