beautypg.com

Mount the wings – Flyzone FLZA4022 User Manual

Page 9

background image

9

single, lower tone beep (“BEEEP”) followed by a shorter, higher
tone beep (“beep”). If the chimes and beeps do not sound in
this manner refer to “MOTOR/ESC OPERATION” on page

15 to setup the transmitter and ESC correctly.

A magnetic screwdriver, or a small magnet stuck to a screw
driver to make it magnetic, will be helpful for the next couple
of steps.

3. Remove the screw from the connector on the elevator

servo arm.

4. Lightly wet the threads of the screw with threadlocker.

5. Reinstall the screw, but do not tighten yet. With the

transmitter and receiver on, center the elevator and tighten
the screw to lock the pushrod down.

6. Repeat the same procedure for the rudder, making

sure it is centered. Lock the pushrod down with the screw
and threadlocker.

7. Disconnect the battery and turn off the transmitter.

Mount the Wings

1. Fasten the wing clips to both sides of the fuselage with

four M3x10 screws.

This manual is related to the following products: