Flintec II PC-BASED - Manual (Page 25)

FlintWeigh Technical Manual, Rev. 3.03 November 2011 Page 25 of 32
8. Legal for Trade Operation
8.1. EC Type-approval and Test Certificate
See documents on the Flintec CD.
8.2. Digital Descriptive Plate
The digital descriptive plate will be displayed after opening the service functions (window FlintWeigh II Settings)
and selecting the register „Information“:
Fig. 9.1 Digital descriptive plate
The digital descriptive plate must conform to the physical
descriptive plate.
(1) Version and revision of the software, checksum in
legal for trade applications in parentheses
(2) Hint area in non-approved applications
(3) Metrological symbol "M": green = approved, red = not
approved
(4) No. of EC type-approval
(5) Electronic calibration counter "TAC"
(6) Logo and address of the owner of the EC type-
approval
(7) Parameters of the selected scale
(8) Parameters of the weighing system controller and the
LDUs
Here you can also enable the 10-times higher resolution
display mode.
8.3. Recording of Weight Values in the Alibi Memory
Fig. 9.2 Successful recording of weight values
Click the button within the weight display
The window „Information“ will be opened:
Here the record no. and the weight value to record will be
displayed.
For transfering them into the alibi memory click the “OK“ button.
Fig. 9.3 Prevented recording of weight values
If the error message „Recording is not possible“ appears, then
the scale was in motion or any of the enabled record locks (see
register „Parameters“) has prevented the successful recording.