FingerTec FMM-100 - Manual (Page 35)

35
Chapter 10
Work Code
A majority of FingerTec Terminals incorporate a feature which allow users to select
a reason for re-entry during verification by electing a work code (for example, work
code 13 – Onsite at Customers).
Adding a Work Code
By default, our terminals does not contain any workcodes.
To add a workcode:
Go to Menu > Work Code > New Work Code > Key in the workcode
• ID: The work code ID supports 1 digit to 8 digits in length.
• Name: Short description of the work code.
All Work Codes
All work codes can be viewed, deleted or edited (with the exemption of modifying the
ID number) in the All work codes tab. The process of editing a work code is similar to
adding a work code as explained in 10.1.
To view all work codes:
Go to Menu > Work Code > All Workcodes > Select the Workcode > Press OK to Select
either to Edit or Delete the selected Work Code.
Work Code Options
The option to use work codes must be enabled before it can be utilized.
To turn on Work Code:
Go to Menu > Work Code > Work Code Options > Work Code Required > Press OK to
turn it ON
Note: If you wish to bar employees from entering new workcodes during verification, you
must enable the function “Work Code must be defined”. The terminal will reject work
codes it cannot match to in its current list.