Enabling wiegand – FingerTec FMM-100 User Manual

Page 16

Enabling Wiegand

Wiegand is used as a bridge between FingerTec devices and 3rd party door Access Con-
troller. It can only be used with Access Control Hardware. Please disregard this section if
you are not using a 3rd party door Access Controller.

FingerTec devices supports 26-bits and 34-bits Wiegand data for input and output. Refer
to the steps below to pair your FingerTec device with your door controller or reader.

To configure:

Step 1:

COMM. Settings

Wiegand Setup

Select either Wiegand In or

Wiegand Out

OK.

Step 2:

Configure the Wiegand data settings

• Wiegand Format:

Select both 26-bits and 34-bits

• Wiegand Bits:

Specify the number of bits occupied by the Wiegand.

• Pulse Width:

The default pulse width is 100 microseconds. It can be adjusted to be-

tween 20 and 100

• Pulse Interval:

Is configured to 1000 by default. It can be adjusted to between 200 and

1000

• ID Type:

Identifies the content of the data output by Wiegand (Card / Password ID)

• Format Details:

Displays information from Wiegand