Emerson Radio ES9 - Manual (Page 10)

9
12. / buttons:
• Tuner Mode: Press to tune up or down and select the desired frequency.
• CD Mode – Press to skip tracks or perform high speed music search.
NOTE: The / buttons on the Remote Control cannot be used for
radio tuning.
13. MODE button – press to enter clock, timer, or calendar setting mode.
14. DISPLAY (DIS) button – press to cycle the display through the time,
temperature, date, and alarm display modes.
15. AM/FM button – press to cycle between the AM and FM radio bands.
16. COLOR button – press to select the display backlight color (7 colors are
available).
17. REMOTE SENSOR – receives the signals from the remote control handset.
18. CD DOOR.
19. SPEAKER TERMINALS – connect the speaker wires to these terminals.
20. PHONES JACK – connect stereo headphones (not included) for private
listening.
21. FM WIRE ANTENNA.
22. RESET button (inside pin hole) – resets the unit to original factory settings in
case of a computer lock-up.
23. BACKUP BATTERY COMPARTMENT – for clock, timer, and preset station
memory backup.
24. AM FREQUENCY STEP switch – selects either 10 kHz (for USA) or 9 kHz
(for Europe) AM tuner frequency steps.
NOTE: This switch has been set to “10 kHz” at our factory and it should be left
in the 10 kHz position.
25. MUTE button (Remote Control only) – press to temporarily shut off the
speakers. The CD door lighting flashes. Press again to cancel Mute and restore
the sound.
26. CH - / CH + buttons – scroll through to select the radio preset stations.
REMOTE CONTROL BACK OF LCD DISPLAY
ES9_ib.p65 16/10/2001, 10:28 9