Eliminator Lighting Electro Ray User Manual

Page 3

MENUS: To access these menus you must press the ESC button twice and then press the UP button until
you find the specific menu you are looking for.
A001: At this menu you can set the DMX address. Press the Enter button, and the “A” will start flashing. Press
the UP or Down buttons to find your desird address. When you have found your desired address press the
Enter button to set it.
TEST: In this menu you can select one of three test modes to run. Using the Up button scroll to “test” and
press Enter. It will now display “Mode 1”. You can scroll to another test mode by pressing the Up button. To
select your desired test mode press the Enter button. Then press the Up button to access the Speed menu.
Adjust the speed, and then press the ESC (Escape) button. The test mode should now be activated. To pause
the test mode, press Enter. If you want to stop test mode, pause it and then press ESC.
AUDI: In this menu you can activate Sound Active mode. Using the Up button scroll to “AUDI” and press
Enter. Press the Up button until “On” is displayed, and press Enter. Now, press ESC, so that the address is
showing. It will take about 10 sec. for Sound Activity to start. The display will flash TEST RUN. Don’t worry the
unit will be sound active.
R.S.E.T. (Reset): In this menu you can activate reset function. Using the Up button scroll to “r.S.e.t.” and
press Enter. The unit will now begin to reset.