Eliminator Lighting Electro 56 LED - Manual (Page 2)

©Eliminator® Los Angeles, CA. - www.EliminatorLighting.com
Universal DMX Control: This unit allows you to use any universal DMX-512 controller to control the
different DMX traits. A DMX controller allows you to create unique programs tailored to your individu-
al needs.
1. The Electro 56 LED uses four DMX channels.
2. To control your fixture in DMX mode, follow the set-up specifications that are included with your
DMX controller.
3. Set dipswitch 10 to the “On” position.
4. Use the controller’s faders to control the various DMX fixture traits.
5. For longer cable runs (more than a 100 feet) use a terminator on the last fixture.
6. For help operating in DMX mode consult the manual included with your DMX controller.
Master-Slave Operation: This function will allow you to link up to 16 units together and operate with-
out a controller. In Master-Slave operation one unit will act as the controlling unit and the others will
react to the controlling units operation. Any unit can act as a Master or as a Slave.
1. Using standard XLR microphone cables, daisy chain your units together via the XLR connector on
the rear of the units. Remember the Male XLR connector is the input and the Female XLR con-
nector is the output. For longer cable runs we suggest a terminator at the last fixture.
2. The dipswitch settings for Master/Slave mode is as follows: Master unit set your desired running
mode, then connect the slave units and set dipswitches 1 & 10 to the “On” position.
Stand Alone (Manual Mode with Strobe):
1. Plug the fixture in, dipswitch controls are as follows: dipswitch 1 is Red, dipswitch 2 is Green,
and dipswitch 3 is Blue.
2. Use dipswitches 4-6 to control the speed of the strobe.
Stand Alone (Auto Mode):
1. Plug the fixture in, and put all dipswitches in the “Off” position. Use dipswitches 7 & 8 to control
the color fade speed.
Stand Alone (Sound Active Mode):
1. Put dipswitch 9 in the “On” postion.
DMX TRAITS:
CHANNEL 1: RED
0 - 255 =
0% - 100%
CHANNEL 2: GREEN
0 - 255 =
0% - 100%
CHANNEL 3: BLUE
0 - 255 =
0% - 100%
CHANNEL 4: DIMMER/STROBE
0 - 189 =
DIMMER 0% - 100%
190 - 250 = STROBE SLOW - FAST
251 - 255 = NO FUNCTION