ebm-papst VDC-3-49.15 - Manual (Page 3)

VDC-3-49.15
Assembly instructions
Article No.: 194 0005 008 · Version: V1.0 · dated 08.11.2011 · Page 3 of 14
ebm-papst St. Georgen GmbH & Co. KG · Hermann-Papst-Straße 1 · 78112 St. Georgen · Phone: +49 7724 81-0 · Fax: +49 7724 81-1309 · www.ebmpapst.com · [email protected]
Ori
g
inal installation
1.9 Noise emissions
Sound pressure level, SPL Lp < 63 db(A) (measured at free-running speed
and at a measuring distance of 250 mm).
Reference value valid for product number 937 4915 600.
1.10 Hot surface
CAUTION
High temperature on the motor.
Danger of burn injuries from hot surface.
Æ
Ensure that sufficient protection against accidental
contact is provided.
1.11 Transport/storage/unpacking
⇒ Transport the motor in its original packaging only.
⇒ Check the motor after receipt to ensure that it is complete and
undamaged.
⇒ Store the drive system in the original packaging, in a dry and clean
place protected against weather conditions.
⇒ Protect the drive system from environmental impacts and dirt until the
final installation.
⇒ We recommend storing the drive system for a maximum of one year.
⇒ Observe the transport and storage conditions (refer to Chapter 3.4).
CAUTION
Motor is heavy.
The motor can fall down and cause crushing injuries.
Æ
Wear safety shoes.
1.12 Disposal
⇒ When disposing of the drive system, comply with all relevant
requirements and regulations applicable in your country.
By request, a materials list can be created for various purposes. (Ex. RoHS,
REACH, overview of insulation materials)
2 USE
2.1 Proper use
The drive systems of the VDC-3-49.15 series are determined for installation
in stationary end devices and machines in the industrial area and must be
operated on electricity only when in installed condition!
Therefore, it must not be put into service until the machinery into which this
product is to be incorporated has been found and declared to be in
conformity with the protection requirements of the Machinery Directive.
This product is not intended for the end consumer. No provision is made for
use in a residential environment without further testing and the use of
correspondingly adapted EMC protective measures.
2.2 Reasonably foreseeable misuse
In particular, the following uses of the drive system are prohibited and can
lead to dangerous situations:
• Operating the drive system in the vicinity of flammable materials or
components.
• Operating the drive system in an explosive atmosphere.
• Using the drive system as a safety system component or for the
assumption of safety-related functions.
• In addition, all application options that are not listed under proper use.