ebm-papst VDC-3-49.15 - Manual (Page 13)

VDC-3-49.15
Assembly instructions
Article No.: 194 0005 008 · Version: V1.0 · dated 08.11.2011 · Page 13 of 14
ebm-papst St. Georgen GmbH & Co. KG · Hermann-Papst-Straße 1 · 78112 St. Georgen · Phone: +49 7724 81-0 · Fax: +49 7724 81-1309 · www.ebmpapst.com · [email protected]
Ori
g
inal installation
7.2 Restarting after a fault
After a fault or safety shut-off occurs, an fault-signal is transmitted at output
"D" and the power stage is switched off. The drive cannot be switched on
again until the enable input "C" (switching with a rising switching edge) is
acknowledged.
NOTE
If a fault remains even after you carry out the remedies
described here, please contact ebm-papst.
7.3 Cleaning
NOTE
Possible damage of the drive system during cleaning
Danger of malfunctions.
Æ
Do not clean the drive system using a water jet or high-
pressure washer.
Æ Do not use any cleaners containing acids, bases or
solvents.
7.4 Safety inspection
Carry out the following visual inspection before each time you start up the
drive system.
• Visual inspection for damage
• Visual inspection for adequate mechanical fastening
• Visual inspection for correctly routed connection lines and
insulation.
7.5 Service and support
If you have any questions or problems, the following contact options are
available to you to provide support and consulting:
• The contact persons of the respective subsidiaries.
• Your responsible domestic regional contacts.
• The responsible contacts for support in inside sales.
Contact address:
ebm-papst St. Georgen GmbH & Co. KG
Hermann-Papst-Str. 1
D-78112 St. Georgen, Germany
Phone: +49 7724 / 81 - 0
Fax: +49 7724 / 81 - 1309
E-mail: [email protected]
7.5.1 Approval and marking
ebm-papst St. Georgen GmbH & Co. KG does not mark the drive systems
described in these assembly instructions with the "CE" mark and does not
issue an EC Declaration of Conformity. This decision is based on
consideration of the relevant EC Directives.
Low voltage directive 2006/95/EC and EMC directive 2004/108/EC:
The drive systems described in these assembly instructions do not fall within
the scope of application of these two guidelines.
Machinery Directive 2006/42/EC
According to the definition of the term in Art. 2, lit. g), a drive system is an
"partly completed machinery" and thus does not receive a CE mark, but falls
under the process for incomplete machines according to Art. 13.
Assembly instructions (which is this document) to Annex IV and a
Declaration of Incorporation (refer to Chapter 8 of the assembly instructions)
to Annex II, Part1, Section B is available.
The specific technical documents to Art. 13, Sect. (1), lit. a) have been
created in-house and are archived for the government agencies of the
individual countries.
The products described in the assembly instructions fulfil the valid directives
for RoHS-compliant products. Other toxic substances are not used in any
unacceptable quantity or concentration. By request, we can create a material
overview list for different specific requirements.