ebm-papst VDC-3-49.15 - Manual (Page 2)

VDC-3-49.15
Assembly instructions
Article No.: 194 0005 008 · Version: V1.0 · dated 08.11.2011 · Page 2 of 14
ebm-papst St. Georgen GmbH & Co. KG · Hermann-Papst-Straße 1 · 78112 St. Georgen · Phone: +49 7724 81-0 · Fax: +49 7724 81-1309 · www.ebmpapst.com · [email protected]
Ori
g
inal installation
1.1.2 Pictograms
These pictograms are used in these assembly instructions and on the motor
if necessary.
Warning of a general hazard.
This warning sign appears in front of activities for which
hazards can be caused by multiple reasons.
Warning of hazardous electrical voltage
This warning sign appears in front of activities that carry a risk
of electric shock, possibly resulting in death.
Warning of hot surface
This warning sign appears in front of activities in which
hazards from hot surfaces exist.
Warning of property damage.
This warning sign appears in front of activities for which a risk
of property damage exists.
1.2 Information symbols
• For bulleted lists.
Æ Measures to avoid dangers.
⇒ Instructs you to take action.
1.3 Type plate
The type plate is installed on the edge of the motor flange.
1.3.1 Design of type plate
937 4915 6XX
XXVDC WW/YY XXXX XXXX
3
2
4 5
1
Fig.1 Design of type plate
1. Manufacturer
2. Product number
3. Serial number
4. Date code
5. Nominal voltage
1.4 Staff qualification
Only specialised electrical personnel may install the drive system, perform
the test run and work on the electrical system.
Only trained and authorised specialist personnel are permitted to transport,
unpack, assemble, operate or maintain the drive system, or to use it in any
other manner.
1.5 Basic safety rules
The safety hazards originating from the drive system must be re-evaluated
after installation in the end drive system.
When working on the drive system, observe the following information:
⇒ Do not make any modifications, additions or conversions to the drive
system without the approval of ebm-papst.
1.6 Electrical voltage
⇒ Check the electrical equipment of the drive system on a regular basis.
⇒ Remove loose connections and defective cables immediately.
1.7 Electromagnetic radiation
Interference from electromagnetic radiation is possible, e.g. in conjunction
with open and closed-loop control devices.
If unacceptably high interference emission occurs when the device is
installed, the user must take suitable measures.
The product emits high-frequency EMC radiation.
For the respective data, refer to the specification.
NOTE
Electrical or electromagnetic interferences after
integrating the drive system in installations on the
customer's side.
When operating the drive system, interference may occur due
to the high switching frequencies and the switching process.
The electromagnetic compatibility of a machine depends on
the type of installation and the care exercised during
installation.
Æ
Pay particular attention to design, filtering, shielding and
earthing.
Æ Ensure the electromagnetic compatibility in the end
device/installed condition.
1.8 Mechanical movement
WARNING
Rotating shaft.
Body parts that come into contact with the shaft can be injured.
Æ
Secure the drive system against accidental contact.
Æ Before working on the installation/machine, wait until all
parts have come to a standstill.
WARNING
Rotating shaft.
Long hair, loose items of clothing and jewellery could become
entangled and pulled into the drive system.
Danger of severe injuries.
Æ
Do not wear any loose clothing or jewellery while working
on rotating parts.
Æ Protect long hair with a hood.