Comtrol RPSH Windows 2000 - Manual (Page 11)

Configuring Device Properties 11
Configuring Device Properties
You can optionally configure the following Device
Properties:
• Verbose event log for diagnostic purposes.
• Scan rate to adjust latency for timing-critical
applications.
• Enable RS-485 mode.
Use the following procedure:
1. Access the Main Setup screen .
2. Select the Options tab.
3. Enable the features you want to use.
4. If you enable the RS-485 feature, an RS485 tab
appears behind the COM Port Properties tab that
you may need to configure.
Note: Use the Help button if you need detailed
information about procedures or use
context-sensitive help for any field.
Configuring Port Properties
You can also configure specific port properties for this
device:
• Override and lock baud rate
• Timeout on transmit data
• Map CD to DSR
• Map 2 stop bits to 1
• Wait on physical transmission
• Emulate modem hardware RING signal
• Clone all Comtrol ports for this server
• Device Advisor
Use the following procedure to access the Port
Properties tab:
1. Access the Main Setup screen .
2. Highlight the port you want to configure and
select the Properties button.
3. Enable the features you want to use and select the
OK button. To configure all ports on the device
with the same features, select Clone.
Note: Use the Help button if you need detailed
information about procedures or use context-sensitive help for any field.
Adding Additional Devices
Install the device and use the Hardware wizard to install additional devices. If necessary, configure the ports.