Chrysler 2015 200 - Owner Manual - Manual (Page 243)

REVERSE and the system is disabled, the EVIC/DID will
display the “PARKSENSE OFF” message for as long as
the vehicle is in REVERSE.
The ParkSense® switch LED will be ON when
ParkSense® is disabled or requires service. The
ParkSense® switch LED will be OFF when the system is
enabled. If the ParkSense® switch is pressed, and re-
quires service, the ParkSense® switch LED will blink
momentarily, and then the LED will be ON.
Service The ParkSense® Park Assist System
During vehicle start up, when the ParkSense® System
has detected a faulted condition, the instrument cluster
will actuate a single chime, once per ignition cycle, and it
will display the ЉPARKSENSE UNAVAILABLE WIPE
REAR SENSORSЉ, ЉPARKSENSE UNAVAILABLE WIPE
FRONT SENSORSЉ, or the ЉPARKSENSE UNAVAIL-
ABLE SERVICE REQUIREDЉ message for five seconds.
When the shift lever/gear selector is moved to Reverse
and the system has detected a faulted condition, the
Electronic Vehicle Information Center (EVIC) or Driver
Information Display (DID) will display a ЉPARKSENSE
UNAVAILABLE WIPE REAR SENSORSЉ, ЉPARKSENSE
UNAVAILABLE WIPE FRONT SENSORSЉ or
Љ PARKSENSE UNAVAILABLE SERVICE REQUIREDЉ
pop up message for five seconds. After five seconds, a car
graphic will be displayed with ЉUNAVAILABLEЉ at ei-
ther the front or rear sensor location depending on where
the fault is detected. The system will continue to provide
arc alerts for the side that is functioning properly. These
arc alerts will interrupt the ЉPARKSENSE UNAVAIL-
ABLE WIPE REAR SENSORSЉ, ЉPARKSENSE UNAVAIL-
ABLE WIPE FRONT SENSORSЉ, or ЉPARKSENSE UN-
AVAILABLE SERVICE REQUIREDЉ messages if an object
is detected within the five second pop-up duration. The
car graphic will remain displayed for as long as the
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 241