Toshiba MA-141 User Manual
Page 59
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTALLING AND REMOVING THE RECEIPT PAPER ROLL
Fig.
^
Installing the Receipt Paper
11 Open the paper cover and install a new paper roll of the recommended type.
2)
Install it with the receipt paper coming from the bottom of the roll (see
Fig. 1).
31 Fold the paper end at a right-angle and thread it through the receipt paper inlet (see Fig. 2).
4) Depress the R.F. key until the paper end appears at the receipt paper outlet. If the paper ends
do not come out of the receipt paper outlet after the R.F key is depressed, for a while, the paper
is not properly threaded through the paper feed mechanism. Push the paper end through the
receipt paper inlet while keeping the R.F. key depressed (see
Fig, 3).
■ Removing the Receipt Paper
When receipts with a red line are issued, the register is running out of the receipt paper. Replace the
receipt paper roll according to the procedure discribed below.
1) Open the paper cover.
2) Remove the paper core from the paper holder, pull out the release lever and pull the paper core
upwards to remove the old paper tail (see
Fig. 4).
INSTALLING AND REMOVING THE JOURNAL PAPER ROLL
1)
2)
3)
Fold the paper end at a right angle and thread it through the journal paper inlet.
Depress the J.F. key until a paper length of about 40 cm is out of the journal paper guide and
wind it around the journal receiving shaft two or three turns in the direction of the arrow (see Fig.
5).
Reinstall the journal receiving shaft in the register (see Fig. 6).
Removing the Journal Paper
When the register is cleared or has run out of the journal paper, remove the journal paper according
to the procedure described below.
1} Open the paper cover.
2) Depress the J.F. key until unprinted journal paper appears.
3) Lift up the printed journal paper with the journal receiving shaft and tear the unprinted portion.
Do not use scissors to cut the journal paper, so that the Torn ends can be matched later, if
necessary (see
Fig. 7).
4) The printed journal roll wound onto the receiving shaft, can be removed, by sliding it off.